Panacol is expanding its portfolio of dual-curing acrylic adhesives with the introduction of Vitralit® UD 8052 F. This material was developed for piezo actuators and sensors.
It possesses a particularly high tear resistance for bonding ceramics and plastics. Vitralit® UD 8052 F is a low viscosity, one-component UV curable adhesive. It is jettable, transparent, and fluoresces under UV light.
Customised versions with different colors are available to facilitate improved process control.Its jet dispense capability makes high UPH (units per hour) values achievable, which is why Vitralit® UD 8052 F is the perfect choice for consumer electronics applications.
This potting compound can be cured in just a few seconds with UV light (320nm – 390nm) or visible light (405nm). The fluorescing adhesive allows in-line process control with short-wave light for maximum productivity. In areas that cannot be reached by light, Vitralit® UD 8052 F post cures with atmospheric moisture and thus polymerises reliably into a flexible potting and glob top compound.Its high tear resistance after curing has been optimized for bonding ceramic components to plastic, compensating for the different expansion coefficients of the bonded materials. Thus Vitralit® UD 8052 F is particularly suitable as a protective coating and for applications subject to tensile and compressive stresses.
As a potting compound, it features a low halogen content, is flexible and offers protection against corrosion and other environmental influences. Vitralit® UD 8052 F – The choice for a low viscosity, one-component UV curable adhesive with a secondary moisture cure for shadowed areas.
ECT Adhesives does not just sell a product, we take an application from the beginning to the end providing expert advice and support throughout.
We are more than happy to call to you and demonstrate this product and show how we can make your products better and your workplace more efficient.
Just reply to this email and we can discuss how ECT adhesives can help you.
ECT Adhesives – The Power to Imagine a better manufacturing process.